REMKO MXD 202 - Manual (Page 12)

4 Operation
The indoor unit is easily operated using the
standard infrared remote control. The indoor unit
beeps to acknowledge the correct transmission of
data. If it is not possible to program the indoor unit
using the remote control, it can also be manually
operated.
Manual operation
The indoor units can be started manually. Press
the "MANUAL" button on the receiver unit of the
cover to activate automatic and the ooling mode
then. The third press turns the unit off. A pressing
again switches back to automatic mode. Within the
whole plant, the unit having manually setting the
cooling mode will be the guide unit. In manual
mode, the following settings apply:
Cooling mode: 24 °C, fan speed: AUTO
Heating mode: 26 °C, fan speed: AUTO
Pressing any button on the infrared remote control
interrupts manual mode.
Infrared remote control
The infrared remote control sends the programmed
settings over a distance of up to 6 m from the
receiver of the indoor unit. Data will only be
received correctly if the remote control is pointed at
the receiver and no objects obstruct the transmis-
sion path.
First insert the batteries supplied on delivery (2 x
type AAA) into the remote control. To do so, pull
off the flap of the battery compartment and insert
the batteries according to their polarity (see mark-
ings).
max. 6 m
Fig. 4: Maximum distance
Alarms are indicated by a code (see chapter
Troubleshooting and customer service).
NOTICE!
Immediately replace flat batteries with a new
set, otherwise there is a risk of leakage. It is
recommended that the batteries are removed if
the equipment is shut down for longer periods.
Help save on energy consumption in stand-by
mode! If the device, system or component is
not in use, we recommend disconnecting the
power supply. Components with a safety func-
tion is excluded from our recommendation!
REMKO MXD
12