REMKO MXD 202 - Manual (Page 39)

12 Care and
maintenance
Regular care and observation of some basic points
will ensure trouble-free operation and a long
service life.
DANGER!
Prior to performing any work, ensure the equip-
ment is disconnected from the voltage supply
and secured to prevent accidental switch-on!
Care
n Ensure the unit is protected against dirt, mould
and other deposits.
n Clean the unit using a damp cloth. Do not use
any caustic, abrasive or solvent-based
cleaning products. Do not use a jet of water.
n Clean the fins on the unit prior to long shut-
down periods.
Maintenance
n We recommend a maintenance contract with
annual maintenance interval with an appro-
priate specialist company.
This enables you to ensure the operational reli-
ability of the plant at all times!
Cleaning the cover of the indoor unit
1. Disconnect the supply voltage to the equip-
ment.
2. Open and fold down the air inlet guard on the
cover. The filter is held in place by the flaps
screwed in at the side of the guard (Page 16,
Fig. 1). (Fig. 45 ).
3. Clean the guard and cover using a soft,
damp cloth.
4. Switch the supply voltage back on.
Type of task
Checks/maintenance/inspection
Commis-
sioning
Monthly Every 6
months
Yearly
General l l
Check voltage and current l l
Check function of compressor/fans l l
Dirt on condenser/evaporator l l
Check refrigerant fill quantity l l
Check condensate drainage l l
Check insulation l l
Check moving parts l l
Sealing test for cooling cycle l l 1)
1) See note
NOTICE!
Statutory regulations require an annual leak test for the cooling cycle dependant on the refrigerant quan-
tity. Inspection and documentation of the work performed is to be carried out by specialist technicians.
39