QuickLabel R-310 QuickWrap - Manual (Page 4)

4
SECTION 1 OVERVIEW
INTRODUCTION
Thank you for purchasing the R-310 semi-automatic round product label
applicator. The R-310 is known for high quality and operating convenience. With
proper maintenance it will provide many years of dependable and trouble free
service. We wish you much success with this product and will always welcome
any suggestions you may have as to how we may improve our products. Read
this manual and familiarize yourself with the machine before using this
equipment.
Operation:
A round product is placed on the carriage rollers and against the end stop. When
the operator presses the foot switch, a time delay cycle that controls an air
cylinder is activated, the drive roller starts to rotate, and the label starts it’s
dispense cycle. Air supplied to the cylinder causes the carriage holding the
product, to be elevated into contact with the drive roller. When the product
makes contact with the drive roller, it will start to turn. At this point, the label is
being peeled from the backing paper and will contact the product just in front of
the drive roll. As the product continues to turn, the drive roller will press the label
onto the container until the label is completely applied. The carriage will drop,
the product can be removed, and the machine is ready to repeat the cycle.