QuickLabel R-310 QuickWrap - Manual (Page 16)

16
4. Place a product on the rollers and move the product and roller assembly so
the product contacts the drive roll evenly.
5. Position the whole carriage at an angle (see Fig 10b). This is so the label
starts onto the product at an angle. This may seem contradictory, but the label
must start at an angle so it ends up looking straight on the product.
The Drive roller may need to be moved to allow the product contact the roller
parallel by loosening the 4 set screws (see ‘L’ Fig 10c). Also the bottle stop was
positioned so the product rests against it for consistent label placement.
Snug all screws and label a product or two and examine it for wrinkles or
position. Tighten all screws when adjustments are finished.
Fig 10b
Note: Tapered
Product must
contact Drive
roll parallel for
straight label
transfer.
Fig 10c
L