QuickLabel R-310 QuickWrap User Manual
Page 14
14
VERTICAL CARRIAGE ADJUSTMENT
This adjustment provides a means to relocate the lower carriage roller assembly
into one of several pair of holes in the actuator arm, as shown by dotted lines in
Fig 8. The purpose is, to minimize the distance the product has to travel to
contact the drive roller (see ‘X’ Fig 6) page 12). To adjust the assembly loosen
the two 8-32 screws (see ‘E’ Fig 8 & Fig 9) on side of actuator arms and relocate
roller assembly. Use 8-32 screws ‘F’ to adjust bottle stop ‘G’ to best position the
label onto the product. The view of the carriage is set to run a Fasson chart #4
(left side off first) die cut label.
Standard
Carriage
Assy.
G
Use one
of several
pairs of
holes
E
F
F
G
Fig 8
Fig 9
E