QuickLabel R-310 QuickWrap - Manual (Page 15)

15
CARRIAGE ADJUSTMENT FOR TAPERED PRODUCTS
A tapered product can be labeled on the R-310 by adjusting the carriage as
follows.
1. Remove the tie bars on the bottom of the carriage assembly (see ‘H’ Fig. 10).
There are 8 screws as shown in (see ‘J’ Fig 10).
2. Loosen the screws on the carriage blocks (see ‘K’ Fig 10a.)
3. Separate or move closer the rollers on one or both sides of the carriage
depending on the taper of the product.
J
H
Fig 10
K
Fig 10a