QuickLabel R-310 QuickWrap - Manual (Page 25)

25
SECTION 4 MAINTENANCE
GENERAL MAINTENANCE
Drive rolls:
The drive rolls must be kept clean. Wash with lacquer thinner or other
recommended solvents to remove gum buildup or small bits of labels adhering to
rollers. Never use razor blade or sharp instruments on rollers. Damaged or
gummy rollers will cause inconsistencies in label application. If they are
damaged, replace them. Part Number “SRL-500-3403875” both rollers are the
same.
Lubrication:
The only part in the applier that requires lubrication are the 2 main shafts (drive
and rewind) that rotate in bushings. These bushings should be oiled once every
2 or 3 years. Remove cover to oil internal bushings as shown below in Fig 19b.
Oil here
Fig 19a
Fig 19c
Fig 19b
Oil here