QuickLabel QLS-4100 Xe - Manual (Page 173)

QLS-4100 Xe 8-17
2 Tighten only the inside (right side) set screw. The outer (left side) set
screw will be tightened later.
3 Thread the liner over the liner guide and attach it to the rewind core. Set
the rewind motor torque to a functional low setting. Press and hold the
FORM FEED/ADVANCE key and observe how the media tracks through
the printer onto the rewind core.
4 If necessary, move the outside (left side) of the liner guide forward.
This adjustment should be made while the liner is feeding so you can see
the adjustment result. Once the optimum setting is found tighten the
outer (left side) set screw.
5 Print a batch of labels in Single Label Mode and observe the liner
tracking. Adjustments to the liner guide may be necessary to fine tune
the tracking in this mode.
6 Adjust printer alignment using the Cross Web Adj and Print Line Adj
menu options, if necessary. Refer to Chapter 4: Keypad Controls and Menus
for more information.
Liner Guide Adjustment Notes
• Narrow media has a tendency to track away from the inside of the
printer. Adjusting the outside of the liner guide forward will correct this
issue.
• Observe the tension across the liner before it reaches the liner guide. This
will indicate how you will adjust the angle of the liner guide.