OnLine Power Signal Saver IPC - Manual (Page 75)

6002-1842 Rev A ECO# 8881
65
3. To change the battery test period, type 300 and press Enter.
The words “Enter password” appear on the screen. Type the password (the factory set password is
1111) and press Enter. If the wrong password is typed, the screen displays “Error in entering data…
please try again.” Type the correct password and press Enter.
The Set Battery Test Period screen appears as below (Figure 40).
Type in the new value within the acceptable range and press Enter to change the test period and go
back to the maintenance menu screen.
4. To change the Battery Test On/Off status, type 301 and press Enter. The words “Enter password”
appear on the screen. Type the password and press Enter. The battery Test Screen appears (Figure
41).
Figure 41
Battery Test Screen
Type 1 to start the battery test or 2 to stop the battery test and press Enter. This changes the battery
test status and sends you back to the maintenance menu screen.