Nortec BACnet - Manual (Page 8)

BACnet & LONWORKS Supplemental Install Manual | 4
BACnet IP
For BACnet IP networks, the recommended wire type is standard Category 5 Ethernet Cable
(CAT 5) with RJ-45 terminations (Category 5E and category 6 cable are also acceptable). Refer
to the BMS supplier for maximum recommended lengths of CAT5 cable.
Table 2: BACnet IP Parameters
Signal Type
BACnet IP
Recommended Cable
Address
Maximum
Recommended Distance
from NORTEC Humidifier
Transmission
Mode
Port
Node
ID
Device
Instance
LAN
Standard
UDP 47808
Category 5 Ethernet
Cable (CAT 5 or better)
with RJ-45 termination
79* 12*
Depends on cable
manufacturer, refer to
BMS Supplier for
recommendations
*Default, may vary for multi-unit orders.
Wiring connections are made directly to the integrated controller circuit board. Figure 1:
Location of Integrated Controller Board shows the location of the board inside the NH-EL.
Figure 1: Location of Integrated Controller Board