Nortec BACnet User Manual
Page 24
BACnet & LONWORKS Supplemental Install Manual | 20
Figure 11: Software Retrieval
Once this software has been installed, use the following procedure:
1. Locate desired humidifier. Ensure unit is powered on and remove the panel on the Front
side of the humidifier. Locate the Integrated Controller Board inside of the unit.
2. Connect one end of the CAT5 cable into the Ethernet port on the Optional Interface Card
directly.
3. Connect other end of CAT5 cable to the Ethernet port on the laptop.
4. Run the “Remote User Interface” utility by double clicking the shortcut on your desktop (or
Start>Programs>Fieldserver Utilities>Remote User Interface)
5. The program should automatically recognize connected humidifier and bring you to the
“Main Menu”. If it does not, contact Nortec Technical Services at the number on the back
cover of this manual.
6. Type “u” for upload.
7. Type “o” for other. (A warning will appear, press any key to continue.)
8. Type “r” for remote.