Installation, Installing the horizontal louvres – Montigo H34DL User Manual
Page 28
H-Series DL Indoor Gas Fireplace
Page 28
XG0140 - 070714
Installation
Figure 32f. Placing Embers.
Step 9. Place the Embers as shown in figure 32f.
Arrange the ember chips on top of the burner tray. Care should be taken
when placing the embers, as blocked burner ports may cause an
incorrect flame pattern, carbon deposits and delayed ignition. Also,
the embers must never be placed in a way that obstructs any of
the air inlet ports, located at the rear of the burner, as shown in
figure 32a.
Place Embers in this area
Installing the Horizontal Louvres:
1. Ensure the fireplace is turned off before beginning installation.
2. Install the upper louvre assembly as shown in figure 33a. Before
tightening the screws fully, adjust the louvre assembly so that it is
centred horizontally and vertically.
3. Install the lower louvre assembly. Line up the slots on each side of
the bottom louvre with the hinge tabs at the base of the fireplace
as shown in figure 33a.
Figure 33a. Installing the lower louver assembly
Figure 33. Installing the upper louver assembly