Montigo H34DL - Manual (Page 25)

H-Series DL Gas Fireplace
Page 25
XG0140 - 070714
Installation
Installing the Logs:
The HC34DL* is supplied with a seven piece ceramic fibre logset. Unpack
the logs and handle them very carefully.
Step 5. Place the left two logs, and the centre log shown below in
figure 30c.
Step 4. Place the top logs from left to right in the order as shown in
Figure 30. These logs balance in the grooves of the base logs
and do not lock into place.
Figure 30. HC34DF's seven piece logset.
Figure 30a. Rear Log placement.
Figure 30c. Left and Center log placement.
Figure 30d. Right log placement.
Step 6. Place the right two logs as shown in figure 30d.
Figure 30b. Front Log placement.
Step 2 Place the Rear Log in position at the back of the fireplace as
shown in Figure 30a below.
Front Log
Rear Log
Upper Logs
Step 3. Place the Front Log in position just behind the black grate as
shown in Figure 30b below.
Step 7. Start the fireplace. If the flame appears satisfactory, replace
the glass door. If the flame does not appear satisfactory,
double-check the air inlet and exhaust outlet pipe to ensure
that they are unobstructed.
Step 1. Remove the glass door as described in the previous instruction.
XW2044
If logs are not placed properly, excessive
sooting will result.
NOTICE
Base Log