Montigo H34DL - Manual (Page 24)

H-Series DL Indoor Gas Fireplace
Page 24
XG0140 - 070714
Installation
Section 8: Installing the Accessories
Top Right Log
Embers
Embers
Embers
Top Left Log
Fireplace Base
Notch
Fireplace Base
Front Left
Base Log
Front Right
Base Log
Notch
Notch
Fireplace Base
Rear / Bottom Log
Notch in Log
Log stand
Log stand
Pilot Assembly
Fireplace Base
Air Inlets
Installing the Logs:
The H34DL* is supplied with five ceramic fibre logs. Unpack the logs
and handle them very carefully.
1. Remove the glass door as described on Page 22.
4. Place the top left log as shown in figure 29d. A flat area is
provided on the front left log, and a notch in the Rear bottom log,
as shown in figure 29b.
Figure 29. H34DL*'s Fireplace Base.
Figure 29a. Bottom/Rear log placement.
Figure 29c. Top Left log placement.
Figure 29d. Top right log placement.
6. Start the fireplace. If the flame appears satisfactory, replace the
glass door. If the flame does not appear satisfactory, double-
check the air inlet and exhaust outlet pipe to ensure that they are
unobstructed.
Figure 29b. Front base logs placement.
2. Install Bottom Rear log as shown in Figure 29b.
3. Install Both front base logs, (Figure 29c) on the log stands provided.
See Figure 29b.
5. Place the top right log as shown in figure 29d. A notch is pro-
vided on the front right log, and a impression in the Rear bottom
log.
CAUTION!
If logs are not placed properly, excessive sooting will result.
The surface of the logs will crack due to the heat from the flames.
This is a normal occurrence.