MicroE PurePrecision - Manual (Page 8)

Page 8
Cutting the PurePrecision ™ Tape Scale
1.
Uncoil the tape scale and cut it to the
required length using shears.
Note: check the interface drawing to make
sure the scale is cut to the right length.
Securely hold the tape scale close
to the shear (at an approximate
distance of 40mm [1½ inches])
near the point of cutting.
Orient the tape scale
perpendicular to the shear.
Cut the tape scale in a smooth,
continuous motion.
Shear held perpendicular to
the tape scale (NOT INCLINED) Hand approximately at a
distance of 40mm-50mm
(1 1/2 inches to 2 inches)
from the cutting point
Shear held inclined,
not perpendicular,
to the tape scale
NOTE:
When working with any encoder
scale, it is important to use either
finger Cots or talc-free gloves