MicroE PurePrecision - Manual (Page 28)

Page 28
Index and Limit Marker Installation
Stick-On Markers for PurePrecision Laser Tape II (HPTS-) and Performance and Value Linear
Glass (PVGL-). (Not applicable to PurePrecision Marker Tape II Scales)
1.
Put on finger cots or gloves before starting the
index and limit markers installation.
NOTE:
Before installing the Limit and Index
Markers, make sure that the blue
protective film from the PurePrecision
Tape Scale has been removed.
Begin by holding the Limit and Index Marker strip so
that the blue protective film is on top and the reflective
surface is at the bottom.
Remove the marker from a perforated strip by gently
twisting the strip in the area of the marker.
The marker will pull away from the transparent
adhesive liner. Holding only the handle section, slowly
pull the index marker from the perforated sheet. This
will expose the adhesive.
NOTE:
Be sure to hold the Index or Limit Markers
by the handle only. The adhesive on the
handle section can be touched. However,
be careful not to touch the adhesive on
the areas of the markers that will be
applied to the scale.
Handle section Stick-on Index