MicroE PurePrecision - Manual (Page 11)

Page 11
Tape Scale, OPS Side/Top Mount Configurations
Installation By Hand
5.
Install the PurePrecision Tape Scale along the remaining length of the mounting surface.
Press the remaining tape on to the mounting surface with a sliding motion as shown below.
Pull the adhesive liner out of the way during the sliding motion.
NOTE:
Make sure that the tape scale is tight against the “D” reference edge.
Pull adhesive liner out of the way
during sliding motion Sliding motion of finger along the
length of the tape
NOTE:
Be sure to keep the blue top protective film in place.
“D” reference edge as shown in the
interface drawing.