MicroE PurePrecision - Manual (Page 19)

Page 19
Tape Scale, OPS Top Mount Configuration
Installation by Hand Grip Applicator Tool
Reference arrows for Tool and
tape scale orientation
1.
OPS Top Mounted Tape Scale Applicator Tool (Model Number: TSAT-PPT)
The Hand Grip Applicator Tool is needed for tape scale lengths greater than 300mm. It is designed to be hand
held and to slide along either a permanent or temporary mounting edge while tape scale is applied.
Tape scale entry channel
2.
Hand Grip Applicator Tool mounting surface guide edges.
The had grip applicator tool has two guide edges. One is for low guide edge configurations of thickness 0.76mm
(0.030 inches) and one for higher guide edge configurations of thickness greater than 9.5mm (.375 inches).
Refer to the OPS interface drawing for tape scale reference edge “D”
Low guide edge of tool. Mounting
surface edge of thickness 0.76mm
(0.030 inches)
Note: The low guide edge also corresponds to the “D” tape
scale reference edge in the interface drawing.
Low guide edge
D
Low guide edge
NOTE:
For best system performance, talc-free gloves or finger cots should be worn during all steps
of tape scale installation.
Thoroughly clean the scale mounting surface and reference edge using a cotton swab or
lint-free cloth dampened with isopropyl alcohol or acetone. Remove all dust and particles.
Adhesive backing channel
Adhesive backing exit