By hand, for ops side mount and ops top mount, Tape scale, ops side/top mount configurations – MicroE PurePrecision User Manual
Page 10
Page 10
Tape Scale, OPS Side/Top Mount Configurations
Installation By Hand
4.
Place the PurePrecision
™
Tape Scale against the mounting surface “D” reference edge.
Place the 25mm (1 inch) exposed adhesive end of the tape scale against the mounting surface “D” reference
edge as shown and press firmly on the end.
NOTE:
Adhesive exposed by removing the adhesive bottom liner can touch the mounting
surface only once.
3.
Flip the tape over with the 25mm (1 inch) exposed adhesive surface facing down. Be sure not to touch or
contaminate the exposed adhesive surface. Be sure the orientation arrows on the blue protective film point to
the “D” reference edge.
“D” reference edge as shown in the
OPS interface drawing.
Tape scale orientation arrows.