MicroE PurePrecision - Manual (Page 20)

Page 20
Tape Scale, OPS Top Mount Configuration
Installation by Hand Grip Applicator Tool
2.
Hand Grip Applicator Tool mounting surface guide edges (continued)
Higher guide surface of tool. Mounting
surface reference edge is higher than
9.5mm (0.375 inches)
Higher guide edge surface
Temporary straight edge
Guide surface
D
4.18 ± 0.05mm
D
D
= Tape Scale Mounting Surface Reference Edge
(See the OPS interface drawings)
3.
Orienting the Hand Grip Applicator Tool and PurePrecision II Tape Scale
Both Tape Scale arrows, and Applicator Tool orientation arrows need to point in the same direction for
proper orientation.
Also note, the “D” reference edge in the OPS interface drawing. The tape scale orientation arrows always
point to the “D” reference edge. In the example below, the “D” reference edge is shown, with tape scale
orientation arrows pointing to it. The applicator tool orientation arrows are also pointing in the same
direction.
In the example shown below, the left side of the tape scale will need to go into the applicator tool entry
channel first. This tape scale end is referred to as the “correct” end.
Applicator Tool orientation arrows Tape Scale orientation arrows on blue protective film
Left side of tape scale