Hardware setup – Measurement Computing WBK17 User Manual
Page 3

WBK17, Counter/Encoder Module
987996
WBK17, pg. 3
Hardware Setup
Configuration
All WBK17 configurations are controlled by software. The WBK17 requires no hardware settings.
Reference Notes:
➣
Encoder setups for WBK17 applications begin on page 22 of this document module.
➣
Refer to the WaveBook User’s Manual (p/n 489-0901) in regard to power, expansion
control, and expansion signal connections.
➣
When using WaveView you will need to set several parameters so WaveView can best
meet your application requirements. For software information, refer to the
WaveBook User’s Manual (p/n 489-0901).
Power
Power In
[to the WBK17]
The WBK17 can be powered by an included AC power adapter or from any +10 to +30 VDC source, such
as a car battery. Check the WBK17 specifications for current requirements. For portable or field
applications, the WBK17 and the WaveBook can be powered by the DBK30A Battery Module or the
DBK34 UPS/Battery Module. Both devices contain rechargeable battery packs. The WaveBook User’s
Manual (p/n 489-0901) includes details.
Power Out
[to the Encoders]
The WBK17 provides output power of +5V at 1A, and +15V at 500 mA to supply power to encoders.
Power connections from the WBK17 to [up to 4] encoders are made on the snap-in screw terminal block
located on the WBK17’s front panel. Example wiring diagrams for encoders begin on page 23.
You must compute power consumption for your entire system. You may need to use
auxiliary or high-current power supplies. The WaveBook User’s Manual
(p/n 489-0901) includes tables for calculating system power requirements and
discusses power supply options.
Reference Notes:
➣
The WaveBook User’s Manual (p/n 489-0901) provides tables for calculating system
power requirements and discusses power supply options.
➣
Encoder wiring diagrams are included in the Encoder section of functional concepts.
These drawings begin on page 23.
CE Kit
If your WBK17 is to be part of a CE compliant system, you will need to use part
number WBK17-CE KIT. The kit includes the terminal block headers and cable
housings that are needed to cover exposed sections of connectors and wiring, thus
bringing your WBK17 up to meet or exceed CE standards.
For a list of applicable CE Safety and EMC standards, as well as the CE Compliant
Operating Conditions that have been specified for WBK17, refer to the WBK17
Declaration of Conformity, p/n 1064-0740.