beautypg.com

Measurement Computing WBK17 User Manual

Page 27

background image

WBK17, Counter/Encoder Module

987996

WBK17, pg. 27

Wiring for 3 Encoders

The following figure illustrates single-ended connections for three encoders. For differential connections
we would simply make /A, /B, and /Z signal connections to the respective channel slots. With three
encoders it should be noted that there is no separate channel for a third set of Z, /Z signals; thus, in the
following figure Encoder 3 has no Z signal.

The WBK17 can receive input from up to four encoders; however, the WaveView data
acquisition program can accept input from only one or two encoders. To receive input
from three or four encoders [with one WBK17] refer to the Programmer’s Manual
(p/n 1008-0901).

Three Encoders with Single-Ended Connections to WBK17

Connect three encoders to the WBK17 as shown in the table below. Each signal (A, B) can be connected
as a single-ended connection with respect to the common ground or as a true differential input. All three
encoders can draw their power from the power output connector. Connect the encoder’s power input to the
+5V or +15V power, connect the return to COM on the same connector. Make sure that the current output
spec is not violated or a fuse may blow. The programming setup given below is just a representative of
possible options.

Three Encoders – Example Setup

Channel

Connection

Programming Setup

1

Encoder1 – A

Encoder Mode, 1X option, 16-bit counter, Latch on SOS

2

Encoder1 – B

Period Mode, 1Xperiod option, 16-bit counter, Map channel doesn’t gate,
Ticksize to 20000ns

3

Encoder2 – A

Encoder Mode, 2X option, 16-bit counter, Latch on SOS

4

Encoder2 – B

Period Mode, 1Xperiod option, 16-bit counter, Map channel doesn’t gate,
Ticksize to 2000ns

5

Encoder3 – A

Encoder Mode, 4X option, 16-bit counter, Latch on SOS

6

Encoder3 – B

Period Mode, 1Xperiod option, 16-bit counter, Map channel doesn’t gate,
Ticksize to 200ns

7

Encoder1 – Z

Counter in Totalize mode, stop-at-the-top, 16-bit counter

8

Encoder2 – Z

Counter in Totalize mode, stop-at-the-top, 16-bit counter