Dukane Dual Servo Spin Welder 403570-01 - Manual (Page 29)

Dukane Manual Part No. 403-570-01 Page 3
Section 4 - Display and Controls
Touch Screen Display
The display is a 4.6 inch (12 cm) wide by 3.5 inch (9cm)
tall color LCD screen shown in Figure 4-1. It contains
an integrated touch screen with 192 touch–sensitive
cells arranged as 16 rows of 12 columns.
Setup parameters and mode selections are programmed
through the touch screen. A closeup view of the controls
is shown in Figure 4–2. The left side of the display
remains visible for most of the selected functions.
The icon in the upper left corner indicates machine
status. Below that are three touch cells for Run mode
(
RUN ), Weld and Post–Weld Setup ( SETUP ), and Setup
Utilities ( TOOLS ). The functions of these buttons are
covered in Chapter 5. The touch cell on the right labeled
Part Data displays part data for the previously welded
assemblies.
Touch
Screen
Display
Trigger
Indicator
Upper Tooling
Hub
Figure 4–1 Dual Servo Spin Welder Touch Screen
Panel
Figure 4–2 Startup Screen