Legrand IC5400 - Manual (Page 15)

Page 11
301 Fulling Mill Road, Suite G ©Copyright 2008 by On-Q/Legrand,
Middletown, PA 17057 Inc All Rights Reserved.
(800)-321-2343 www.onqlegrand.com
• Insert the Intercom Distribution Module into the mounting bracket and insert the bracket into the
On-Q enclosure. Secure the Intercom Distribution Module to the bracket by depressing each
plunger at each corner of the Intercom Distribution Module.
• DONOT apply power to the Intercom Distribution Module until all RJ45 plugs are seated in the
correct jacks on the Intercom Distribution Module.
• Terminate the other end of the labeled Cat 5e cables, at the Selective Call Intercom
Distribution Module, with RJ45 plugs using the T568A wiring standard and plug them into
the appropriate RJ45 jack.
• After all Units and Distribution Modules are connected apply power to the Intercom
Distribution Module and verify system functionality. All Selective Call Room, Door and Patio
Units will be discovered (see Figure 14) and shown on each Room Unit LCD (see Figure
15).
ROOM1
ROOM2
ALL
PATIO1
SETTINGS
DOOR1
ROOM1
ROOM2
ALL
PATIO1
SETTINGS
DOOR1
SETTINGS
Reply Options
Installer Setup
Room Options
Patio Options
Door Options
SETTINGS
Reply Options
Installer Setup
Room Options
Patio Options
Door Options
ROOM1 INSTALLER SETUP
Reply Options
Door Options
Firmware Info
System Reset
Room Options
Disc. Settings
ROOM1 INSTALLER SETUP
Reply Options
Door Options
Firmware Info
System Reset
Room Options
Disc. Settings
PATIO OPTIONS DOOR OPTIONS
Select Unit:
DOOR1
BACK
PATIO OPTIONS DOOR OPTIONS
Select Unit:
DOOR1
BACK
PATIO OPTIONS
DOOR 1
Release: ENABLE
BACK
Trigger: DISABLE
PATIO OPTIONS
DOOR 1
Release: ENABLE
BACK
Trigger: DISABLE
ROOM1
ROOM2
ALL
PATIO1
SETTINGS
DOOR1
ROOM1
ROOM2
ALL
PATIO1
SETTINGS
DOOR1
Figure 13
Figure 14 Figure 15
Rev v1.0c8.28
Discovering…
My Address:
90:1040
My Name:
ROOM 1
Rev v1.0c8.28
Discovering…
My Address:
90:1040
My Name:
ROOM 1