Legrand inQuire 1000 - Manual (Page 7)

301 Fulling Mill Road, Suite G © Copyright 2006 by On-Q/Legrand Inc. Page 22
Middletown, PA 17057 All Rights Reserved
(800) 321-2343 www.onqlegrand.com
D. Patio Unit
Please refer to Figure 15 to familiarize yourself with the operation of the
inQuire™ 1000 Patio Unit.
Figure 15 - inQuire™
Patio Unit Operation
TALK: Depressing this button will allow you to
communicate with all other active units. Hold in the
TALK button while speaking, and let it go when you are
done. Your voice will be heard on the Main Console
Unit, as well as any active Room, Patio, or Desktop
Unit within the system.
ANSWER LED: This LED is located at the top of the
keypad of the Patio Unit. When lit, the LED indicates
that the microphone in the unit is active and anything
you say will be communicated through the system.
This LED will light when you are depressing the
TALK or DOOR buttons. The LED will be constantly
lit when the unit is in MONITOR mode.
DOOR: Depressing this button will allow you to
communicate with all Door Units that are part of your
system. Hold in the DOOR button while speaking
and let it go when you are done. Your voice will be
heard on any active Room, Patio, or Desktop Units
and all Door Units within the system.
MONITOR: Press this button once to put the Unit in
MONITOR mode. Press the button again to return
the Unit back to normal mode. While in MONITOR
mode, the microphone is constantly active, the
speaker is disabled and any voice or noise within the
room will be heard throughout the system. The LED
to the right of the MONITOR button will glow green
when in MONITOR mode. Multiple Units can be in
MONITOR mode at the same time. This function is
useful for baby monitoring or other types of situations
which require any voice or noise in a room to be
heard throughout the system.
NOTE: When in MONITOR mode, a door bell
button push at a Door Unit will not result in a
door chime ring at the Patio Unit.
VOLUME: There are two volume control buttons
with an associated volume level LED bar. There are
20 different volume levels which are adjusted up and
down using these two buttons. Pressing the volume
up button once will increase the volume one level
higher. You may not see the LEDs change until you
press the volume up or down multiple times
(approximately every sixth button press). You can
also hold in the volume up or down button until you
have reached the desired volume level. It is
recommended that you keep the volume level in the
middle position (3 LEDs lit) for optimum sound
quality.
PATIO UNIT DISABLE: If security mode was enabled
by removing the shunt on J3 on the rear of the Intercom
Module, the Patio Unit can be disabled temporarily by
simultaneously pressing and releasing the TALK and
DOOR RELEASE buttons on the Main Console Unit. The
Patio Unit Status LED should blink slowly Red and then
Green. To re-enable the Patio Unit, again simultaneously
press and release the TALK and DOOR RELEASE
buttons on the Main Console Unit.
NOTE: There is no Door Release function enabled on
the Patio Unit.
MUTE: Press this button once to put the Unit in MUTE
mode. Press the button again to return the Unit back to
normal mode. While in MUTE mode, both the speaker
and microphone of the unit will be inactive and the LED
to the right of the MUTE button will glow red. MUTE
mode is useful for maintaining privacy on the patio.
Multiple units can be in MUTE mode at the same time.
301 Fulling Mill Road, Suite G © Copyright 2006 by On-Q/Legrand Inc. Page 3
Middletown, PA 17057 All Rights Reserved
(800) 321-2343 www.onqlegrand.com
• Patio Unit: This unit also provides typical Room Unit functionality in a
weather resistant wall mounted package for your patio. For security
reasons, its door release functionality may be disabled.
• Door Unit: This unit allows a visitor to the home to press the door chime
button on the unit to notify the occupants of their presence (requires
Door Chime to be installed). The occupants can then initiate a two-way
communication with the visitor and even open the door (requires
electronic door relese device, not included).
• Door Chime: This component installs as an add-on to the Intercom
Module. It enables a chime to be heard on all the units that are not in
MUTE or MONITOR mode throughout the inQuire™ 1000 Intercom
System.