Legrand MRP6 - Manual (Page 5)

unit deScriptiOn
The Miro™ MRP6 Wireless Plug-In Lamp module provides
convenient dimming control for most floor and table lamps.
This simple plug-in module makes it easy to include free-
standing plug-in lamps in the Miro lighting control system.
Miro wireless devices use radio signals to communicate
with each other to control lighting and other types of electric loads in selected
areas. Miro wireless devices use the 900MHz band for high-speed control
communication. Using the “frequency-agile” Top Dog™ technology, Miro wireless
devices avoid interference with other 900MHz devices, such as cordless phones
and baby monitors.
Auto-on Operation
When the lamp has been turned off by the Miro wirless lamp module, you can
still manually turn on the lamp using the lamp’s integral switch. The Miro lamp
module senses the switch opening and closing and immediately applies power to
the load.
load types
Use the MRP6 Wireless Plug-in Lamp Module with floor and table lamps of the
following load types (25-300W at 120V):
• Incandescent and quartz halogen lamps
• Dimmable electronic or magnetic low voltage transformers (max load 250W)
• Dimmable cold cathode, neon ballasts (max load 250W)
• Dimmable 2-wire fluorescent and compact fluorescent lamps
do not mix different load types on the same plug-in lamp module.
Do not use with diode equipped (some types of energy saving) lamps.
do not use with flourescent fixtures other than those listed.
do not use for light fixtures with integral dimmers.
do not use for motors.
Plug-In
Lamp
lamp Module
identification icon
cAutiOn
to reduce the risk of
overheating and possible
damage to other equipment,
do not install to control a
motor-operated appliance, or
a fluorescent lighting fixture.
cAutiOn
Afin de réduire le risque de
surchauffe et la possibilité
d’endommager d’autres
matériels, ne pas installer
pour commander un
appareil à moteur, ou une
lampe fluorescente.