Legrand MRP6 - Manual (Page 2)

cleAninG
Clean using only a cloth dampened with water and a little mild detergent.
Use of solvents or hydrocarbon-based cleaners may cause permanent damage.
trOubleShOOtinG
during Set house id, the led is not flashing on some wireless Miro
devices.
• if led is solid green before initiating house id binding:
The device already has another house ID. Reset it to the factory default so
that it can be bound to the desired house ID. Resetting to factory defaults is
described in the “I need to start over” issue.
• if led is solid yellow after initiating house id binding:
The device may be out of range of the initiating device. Add a MRR2 Miro
Wireless Repeater to boost signal range.
i made a configuration mistake. i need to start over.
You can reset any Miro wireless device to factory default settings by pressing
and holding until the LED changes to solid yellow (approximately 10
seconds). During the process, the LED flashes yellow and when complete, it
changes to solid yellow. The device can then be reconfigured, exactly like any
new device (see the Set House ID section).
the dimmer does not work and the status led is flashing red
• at 2Hz (10 times in 5 seconds):
The module has detected an overload condition and has shut down.
To clear the fault condition, tap and wait for the LED to turn green.
Disconnect loads in excess of rated load and try again.
• at 3Hz (15 times in 5 seconds):
The module has detected a short-circuit condition and has shut down.
To clear the fault condition, tap and wait for the LED to turn green.
Remove power, rectify the short-circuit condition, restore power, and try
again.