Legrand MRH6 - Manual (Page 7)

set house iD
All Miro wireless devices installed in the same home must acquire the same
unique House ID before use. This process is known as house binding. Each Miro
wireless device is bound to all other Miro wireless devices in the house.
new installation
1. With all devices installed and
energized, make sure that every
Miro wireless device LED is yellow.
If any LED is off, be sure the circuit
breaker is on and the device is
correctly installed. The MRH6
remote shuts down when it is not in
use. Press any button to activate the
remote and illuminate its LED.
2. Press on any device paddle until the LED flashes yellow (about 2 seconds).
This indicates that it has acquired a unique House ID.
3. Make sure that all other Miro wireless device LEDs are flashing green,
indicating that they have acquired the same House ID. For MRH5 or MRH6
remotes, be sure that the units are awake during the binding process. Press
any button to activate the remote and illuminate its LED.
4. Return to the device used in step 2, which is still flashing yellow. Press
until the LED changes to solid green (about 2 seconds). All device LEDs in the
House change to solid green, indicating house binding is complete.
adding an mrh6 to an existing installation
If you’re adding or replacing a device in a Miro wireless installation that is
already operating, the new device must be bound to the same House ID as the
other Miro wireless devices in the house. After the new MRH6 is powered up, the
LED should be solid yellow. This indicates that it has not yet acquired a House ID.
To acquire the House ID for the existing system:
1. Press on any previously bound device until the LED flashes yellow (about 2
seconds).
2. Be sure that the MRH6 is awake during the binding process. Press any button
to activate the remote and illuminate its LED. Verify that the new MRH6 LED is
flashing green, indicating that it has acquired the House ID.
3. Return to the same previously bound device used in step 1 and press until
the LED changes to solid green (about 2 seconds). All device LEDs should now
be solid green.
When you see
in the instructions,
firmly press and
hold both the top
and bottom of
the paddle until
the LED changes
(about 2 seconds).
A
E
D
C
B