beautypg.com

More scenes, Lock room configuration, Battery information – Legrand MRH6 User Manual

Page 2

background image

more sCenes

Up to 15 scenes are available per room, in sets of 1‑5, 6‑10, and 11‑15. The

MRH6 can access sets 1‑5 or 6‑10. It is assigned to scenes 1‑5 when shipped.

Binding multiple room level controllers (MRH6, MRD6, or DRD6) to the room and

assigning each to a different scene set, lets you dedicate a controller to each

scene set. You can bind more room scene controllers to the

room to control the same scenes from multiple locations.
All room scene controllers with the same scene assignment

operate the 5 scenes the same way as all other room scene

controllers with the same set. Scene buttons on controllers

with scene set 6‑10 default to 0%/All room devices OFF. Use

ROOM BINDING and CUSTOMIZING OPERATION procedures

to set up the additional scene controllers.
To assign scenes 6-10, simultaneously press and B until

the LED blinks twice (about 2 seconds).
To change the assignment back to scenes 1-5, simultaneously press and a

until the LED blinks twice (about 2 seconds).

LoCk room ConFiguration

The Lock Configuration function operates from a wireless room level controller,

and prevents the Miro wireless devices in the room from being reprogrammed.

Other operations such as dimming, switching and scene recall are not affected.
When the configuration is locked, if is pressed and held on any Miro wireless

device, the device’s LED flashes red and the command is ignored.
to lock the configuration:
Go to any room scene controller. Simultaneously press

and buttons B and e until the LED flashes (about 2 seconds)

to toggle in and out of Lock Configuration.
• If the mode changes from unlocked to locked, the LED

flashes red for 2 seconds, indicating that configuration is

now locked.

• If the mode changes from locked to unlocked, the LED

flashes green for 2 seconds, indicating that configuration is now unlocked.

BatterY inFormation

The MRH6 operates using three 1.5V Alkaline AAA size batteries. The remote
goes to sleep whenever it is not performing a function. When asleep, its LED is
off. To check battery status, press any button to wake up the remote.
important: Observe the color of the LED immediately after you wake it up.

green indicates the batteries are good.
reD indicates the batteries are getting weak and should be replaced.

ROOM REMOTE

4 FINGERS

A

E

D

C

B

52205(027(

),1*(56

$

(

'

&

%

Assigning the MRH6

for scene set 6‑10