Legrand WKD ProSeries Underfloor Duct Rectangular Floor Box Covers - Manual (Page 3)

Gasket
Gasket
Gasket
Support
Plate
SCREW COVER FOR POWER
(ALUMINUM):
1. Connect wire to receptacle and
attach to trim flange.
2. Place gasket support plate over
receptacle.
3. Place gasket over support plate.
4. Attach cover with four (4) flat
head screws.
CAT. NO. 830CKTCLAL
SHOWN
Gasket
Gasket
Support
Plate
BRASS AND ALUMINUM
COVER FOR DATA OR TURN
LOCK RECEPTACLE:
1. Connect wire to receptacle and
attach to trim flange.
2. Place gasket support plate over
receptacle.
3. Place gasket over support plate.
4. Attach cover with four (4) flat
head screws.
CAT. NO. 828DLRAL
SHOWN
1. Connect wires to receptacle and
attach to trim flange.
2. Place gasket over receptacle.
3. Attach cover with four (4) flat
head screws.
4. Install screw plugs when not
in use.
CAT. NO. 828SPTC SHOWN
1. Extend cables through the foam
gasket and cover.
2. Attach cover with four (4) flat
head screws.
3. Install screw plugs when not
in use.
CAT. NO. 829CK-1 SHOWN
BRASS
ALUMINUM
Gasket
CAT. NO. 830CKTCAL3-4
SHOWN
Gasket
DUPLEX RECEPTACLE SCREW PLUG COVER:
COMMUNICATIONS SCREW PLUG COVER:
1. Extend cables through gasket.
Invert slide and re-insert into
cover plate.
2. Attach cover and gasket with
four (4) flat head screws.
3. Adjust slide to accommodate
the size of cable.
CAT. NO. 829PSTC SHOWN
ADJUSTABLE SLIDE COVER:
NOTE: 829PSTC is for cable
egress only, not for
holding data jack.