Legrand OR-GXC422942-A1-B - Manual (Page 9)

Setting Up the Cabinet
Leveling
Tools: Flat Head Screw Driver or 1/2“
Open-end hand wrench (for small leveler)
1. Move the cabinet to desired location.
Use as many people as required to
safely move the cabinet.
2. Open the cabinet door(s). Locate the
holes by the bottom corners of the
cabinet. A slotted, threaded bolt will be
visible through these holes.
3. Insert a flat head screw driver into
the holes.
4. Turn the screw driver clockwise to
raise the cabinet. Turn the screw
driver counter-clockwise to lower
the cabinet. All four leveling feet
must be in firm contact with the floor.
5. Check if the cabinet is level and that
it does not ‘rock’ back and forth.
6. Check if the cabinet is at same height
as to any adjacent cabinets. Make
adjustment(s) if necessary.
NOTE: 1/2“ Open-end hand wrench can be
used to adjust the small (1 1/2“) leveler.
Leveler Foot
Holes
Flat Head Screw
Driver
8
Rev. 00 - 11/11