Legrand RC4KTCBK User Manual
Page 2
Step 5. Guide replacement receptacle brackets into
Step 6. Attach trim ring to bracket with four screws
place. Direct wire leads through indicated
provided. Attach trim ring to receptacle
opening to junction box below.
bracket with two screws provided.
Important: Receptacle bracket slides
into the tabs shown here.
Step 7. Place gasket support on receptacle bracket.
Step 8. Place slide holder on assembly, lining
Place internal gasket on gasket support and
up the “A” and “B” indicators on the
press around edge to seat the gasket into
trim ring and the slide holder. Fasten
the groove in the trim ring.
with two screws provided.
CAUTION: Gasket must be set in place to provide scrub water seal.
Screws Provided
Two Screws Provided
Wire Path to
Junction Box
NOTE: Be certain to line up the trim
ring with the holes on the
receptacle bracket. The trim
ring only attaches one way.
Important: Letter indicators
need to be lined
up for correct
circuit identification.