Legrand RC4KTCBK User Manual
Rc4 replacement scrub water, Cover assembly kit, Installation instructions
IMPORTANT – PLEASE READ ALL INSTRUCTIONS BEFORE BEGINNING.
Products Covered: RC4KTC
CAUTION: Do Not operate tile stripper or resurfacing equipment over top of covers. This may result in damage to the surface finish of the product.
Step 1. Disconnect receptacle wiring in junction box.
Step 2. Remove two screws and slide holder.
CAUTION: De-energize circuit before removing junction box cover.
Step 3. Remove six screws and trim ring.
Step 4. Pull receptacles and receptacle brackets
out of Poke-Thru device.
RC4 Replacement Scrub Water
Cover Assembly Kit
INSTALLATION INSTRUCTIONS
Installation Instruction No.: 1 002 139 R1 – Updated October 2003
Screws
Slide Holder
Screws
Trim Ring
Walker
®
electrical systems conform to and should be properly grounded
in compliance with requirements of the current National Electrical Code
or codes administered by local authorities.
All electrical products may present a possible shock or fire hazard if
improperly installed or used. Walker electrical products may bear the
mark as UL Listed and/or Classified and should be installed in
conformance with current local and/or the National Electrical Code.