Legrand FITFIT Multi-Service Poke-Thru Device Abandonments - Manual (Page 2)

2
FIT Abandoned with Poke-Thru Stem Removed: (Use 221-21CARPET or 221-21TILE)
Step 6: Disconnect electrical service from service fitting. Step 7: Remove side screws and top of 200 or
241 Service Head. Remove receptacles and
communication modules. Remove cables.
Step 8: Remove two anchoring screws and base Step 9: Pull poke-thru device body through
of service head. floor from below.
Pull Down
Step 10: Step 11: Tighten screw clockwise to expand silicone
A. Adjust lower intumescent material to be gasket and complete installation on tile
flush with bottom of floor. The wafer or carpet.
slides along the screw.
Push Down
B. For Carpet: Push plug down
into hole until round plate
seats against concrete.
For Tile: Push plug
down into hole until
rectangular plate seats
against tile surface.
200 Series
241 Series
Silicone Gasket
Glue Carpet Over
Abandonment Fitting Tile
Carpet