K-Patents PR-03 - Manual (Page 78)

78 78
78 78
72 PR-03 instruction manual
8.4.5 PR-03-P mounting specifics
The Probe refractometer PR-03-P is primarily designed for mounting in a tank wall. To ensure that the
measurement is representative and that the prism stays clean, the probe should be installed close to a stirrer,
Figure 8.8.
4-20 mA
~
CHECK CABLE LENGTH
Figure 8.8 Recommendations for mounting the Probe sensor PR-03-P in a tank
K-Patents probe refractometer type PR-03-P62-TSS is connected to the process by a 2 1/2" 3-A sanitary
clamp, Figure 8.9. The type PR-03-P62-RSS type sensor is connected to process by a 4" 3-A sanitary
clamp.
Note: For higher process (or ambient) temperatures, use instead a flush mounted sensor (Figures 8.9, 8.10
and 8.11), where the electronics in the sensor head are further away from the process heat.
Figure 8.9 Insertion of Probe refractometer PR-03-P62-TSS