K-Patents PR-23-SD Generation 1 - Manual (Page 6)

Document/Revision No. BP-EN-SDGEN1 1.0 Effective: April 1, 2013
6
Installation Equipment
Figure 2 Installation equipment
1 Retractor inner casing Supplied by K-Patents
2 Retractor outer casing Supplied by K-Patents
3 Adjustable wrench
4 Combination wrench, 19 mm / 3/4 in
5 Flat head screwdriver
6 Allen key 8 mm / 5/16 in
7 Thread seak tape
8 Sensor insertion / removal instruction card Supplied by K-Patents
9 Product user manual Supplied by K-Patents
NOTE: The material of the SDI valve body that is welded onto a process pipe is Duplex
steel SAF2205 (EN 1.4462, ASTM S32205/S31803). Choose the welding method and
filler accordingly.
K-Patents recommends complying with the applicable EN / ASTM standards.
3 Safety Requirements
These safety requirements must be followed at all times when installing, operating, or
servicing PR-23-SD sensor. These are the minimum safety requirements – your company
may require additional PPE (personal protective equipment).
For more information on safety issues, please see K-Patents Safety Instructions.
PROCESS
REFRACT
OMETER
PR-23
1
2
3
4
5
6
7
9
8