K-Patents PR-23-SD Generation 1 - Manual (Page 4)

Document/Revision No. BP-EN-SDGEN1 1.0 Effective: April 1, 2013
4
● Use suitable type of steam for cleaning the prism. Dry saturated steam and 10-12 bar
(150-180 psi) are recommended.
● Access to steam. The distance between the steam supply and the SD sensor system
should be considered for the length of steam piping.
● Access to drain for steam trap condensate outlet.
● Emergency shower and eye wash should be easily accessible. Water can also be used
for cleaning SDI valve lip seals and sensor after sensor removal.
● Shut-off valve needs pressurized instrumentation air (5-10 bars / 70-150 psi).
● Ensure connection to the power supply (110-230V AC).
If these conditions do not apply, please reconsider the intended location for your installation
or contact K-Patents.
2.2 Component Checklist
Before starting installation, make sure you have all the tools and components listed below.
NOTE: Components 4–6 are connected by union nipple or piping not included in
the delivery.