K-Patents PR-23-SD Generation 1 - Manual (Page 28)

Document/Revision No. BP-EN-SDGEN1 1.0 Effective: April 1, 2013
28
7. OPTIONAL: Setting up an Ethernet connection. Data can be downloaded from the
transmitter to a computer via an Ethernet connection. The Ethernet connector can be
found on the underside of the front panel.
Figure 16 Ethernet connection location
For more information on Ethernet connection, please refer to chapter Ethernet connection
specification in K-Patents user documentation.
5 Commissioning SD Sensor System
After installing the SDI valve, PR-23-SD sensor, and DTR transmitter, go through the
following check list to make sure the SD sensor system is functioning correctly.
For more thorough instructions, please refer to K-Patents user documentation or visit the
K-Patents website to see the instructional video (www.kpatents.com, PR-23-SD Safe-
Drive™ Operation Guide Video).
Commissioning checklist
Safe-Drive start-up
Task
OK Failed Menu path Notes
Check that the wiring has
been done according to the
attached wiring diagram.
Connect the power.
Check that the status is
NORMAL OPERATION
(if there is a sample)
NO SAMPLE
(if the process pipe is empty)
Check process temperatures.
Check the serial number.
Check that the parameters
are set
according to the delivery data
sheet (DDS).
CALIBRATION
› CHEMICAL
& FIELD
PARAMETERS