D-Link DIR-120 - Manual (Page 4)

DIR-120 Ethernet Broadband Router
D-Link DIR-120 User Manual iv
About This User’s Guide
This user’s guide provides instructions on how to install the DIR-120 Ethernet Broadband Router and use it to connect a computer or Ethernet LAN to the Internet.
Before You Start
Please read and make sure you understand all the prerequisites for proper installation of your new Router. Have all the necessary information and equipment on hand before
beginning the installation.
Overview
The procedure to install the Router can be described in general terms in the following steps:
1. Gather information and equipment needed to install the device. Before you begin the actual installation make sure you have all the necessary information and
equipment.
2. Install the hardware, that is, connect the cables (Ethernet and telephone) to the device and connect the power adapter.
3. Check the IP settings on your computer and change them if necessary so the computer can access the web-based software built into the Router.
4. Use the web-based management software to configure the device to suit the requirements of your ISP account.
Packing List
Open the shipping carton and carefully remove all items. In addition to this Manual, ascertain that you have:
• DIR-120 Ethernet Broadband Router
• Power Adapter
• Ethernet Cable
• Quick Installation Guide
• Manual on CD
If any of the above items are missing, please contact your reseller.
NOTE: Using a power supply with a different voltage rating will damage and void the warranty for this product
CAUTION: The Router must be used with the power
adapter included with the device.