D-Link DIR-120 - Manual (Page 10)

DIR-120 Ethernet Broadband Router
D-Link DIR-120 User Manual 4
Rear Panel
Connect the AC power adapter cord and network cables on the rear panel. The power switch and reset button are also located on the back of the device.
Note: All ports (LAN and WAN) are Auto-MDIX. All ports also automatically connect with straight-through
or crossover CAT5 or better Ethernet cable.
USB Port The USB port can be used to share a printer. The printer must support the LPR protocol.
LAN Ports (1 – 4)
Use CAT5 or better Ethernet cabling with standard RJ-45 connectors to connect computers, switches, hubs, wireless access
points or any Ethernet networking device. Use the LAN LED indicators on the front panel to check the Ethernet connection
WAN Port
This port is where the user is to connect the Ethernet cable from an outside source that is taking the connection from your local
ISP.
Power Adapter This is where the user will connect the power adapter, the other end of which will be connected to a power outlet.
Reset Button Pressing this button will restore the DIR-120 to its factory default settings.
LAN Port USB Port WAN Port Reset Button