Kleenmaid KFL2000 - Manual (Page 8)

8
Hose and cable lengths
Connection on left side Connection on right side
b
c
a e
g
f
h h
d
d
a = 140 cm (approx.)
b = 130 cm (approx.)
c = 85 cm (approx.)
d = 100 cm (max.) e = 175 cm (approx.)
f = 88 cm (approx.)
g = 140 cm (approx.)
h = 60 cm (approx.)
h = mininum drain point height Other hoses
Available from specialist dealers:
- Extended supply hose
(approx.Ă2.44 m).
Water connection
Water inlet hose
d Caution!
Operate the washing machine with
cold drinking water only. Do not
connect to the mixer tap of an
unpressurised hotwater apparatus.
Only use the new delivered supply and
drainage hoses. Never connect old
used hoses.
If in doubt, have the appliance
connected by a specialist.
The water inlet hose must not be
- kinked or crushed,
- modified or severed (strength is
no longer guaranteed).
Plastic threads must only be tightened
by hand. Do not remove the strainers
from the water supply hoses.
q Plastic threads must only be
tightened by hand when
connecting the water supply
hoses to the back of the unit. Do
not remove the strainers from the
water supply hose.
Connecting the supply hose:
q After connecting the supply hose,
turn on the tap and check that
water comes out.
Observe the mains water pressure.
- The water pressure should be
between 1 and 10 bars (when the
tap is turned on, at least 8 litres of
water is discharged per minute).
- If the water pressure is higher,
install a pressure reducing valve.
Water drainage hose
Height difference between the
placement area and drainage point:
maximum 100 cm, minimum 60 cm.
Connect the water drainage hose:
q Do not remove the screw from
the clamp assembly. Loosen
the screw only enough so that the
clamp will slide freely onto the
water drain hose.