Kleenmaid KFL2000 - Manual (Page 7)

7
Installation in a recess
If the washing machine is to be
installed in a recess, observe the
minimum distances indicated in the
following table:
Distance
Sides 6 mm
Upper edge 305 mm
Rear 64 mm
Front 6 mm
Remove the
transportation
safetyĂdevices
d Caution!
The transport bolts must always be
removed before using the appliance
for the first time and must be retained
for any subsequent transport
(e. g. when moving).
q Loosen all four bolts before
removing any of the bolts all the
way from the unit.
q Remove the bottom two bolts
prior to removing the top two
bolts.
q Release all screws and using the
SW 13 wrench until they can be
removed freely.
q The recessed bottom bolts may
be more easily removed using a
1/2" (13 mm) socket wrench.
q Completely remove the
transportation safety device
(screw and spring, washer and
bush).
q Insert the covers.
Storing the transportation
protection devices
Always keep the transport bolts for
subsequent transportation of the
appliance (e. g. when moving out).
q If the bushings do not come out
when removing the bolts, place
the bolts back into the bushings
and carefully try again. It is
important to do this with the
bolts, otherwise the bushings will
not come out properly.
q Store transport bolts and (screw
washer and bushing onto bolt).