Kleenmaid KFL2000 User Manual
Page 30
30
Fault
Possible cause
Remedial action
Programme does not
start. Time delay" is
indicated in the display
field.
End time selected and activated.
None. Appliance starts automatically.
Time cannot be set.
Programme has already started; when the programme
has started, the time cannot be set.
Wait until programme ends.
Set clock:" text remains
in the display field even
though the Menu button
has been pressed.
The setting has switched from hours to minutes;
bothĂselection points have the same text.
Set clock; see Page 24.
Time is not displayed.
Time not set.
Set clock; see Page 24.
End time cannot be
Time not set.
Set clock; see Page 24.
selected.
Programme has already started; when the programme
has started, the time cannot be set.
Before starting the programme, select and start the
desired end time, see Page 21.
Spin speed cannot be
selected.
Spin cycle is already running; the speed cannot be
changed during the spin cycle.
Select speed before spinning.
Programme selector is set to Drain b; spinning is
not possible with this programme.
If required, select another programme.
Childproof lock cannot be
selected.
The programme has already started.
Childproof lock can be selected in pause mode.
Detergent residue in the
Damp or lumpy detergent.
Clean and dry the detergent dispenser; see Page 26.
g
detergent dispensers.
p
py
g
Use the cap to measure the liquid detergent.
Water does enter the
machine or detergent is
Mains water tap is not opened.
Turn the tap on.
Programme continues.
g
not washed away.
Water tap closed?"
Inlet hose kinked or pinched.
Eliminate cause.
Water tap closed?"
indicated in the display
Strainers in supply hose clogged.
Clean the strainers; see Page 27.
indicated in the display
field.
Water pressure too low.
Eliminate cause.
Water not visible in the
drum.
Not a fault.
The water lies below the visible part of the drum.
Washing solution is not
completely drained.
Pump blocked?"
indicated in the display
field.
Drainage pipe and/or drainage hose blocked.
Clean drainage pipe and/or drainage hose.
Water runs out from
Screw fitting of the inlet hose is leaking.
Tighten the screwĆfitting.
under the appliance.
Drainage hose is leaking.
Replace the drain hose.
Foam comes out of the
detergent drawer.
Too much detergent.
Add 1 tbs. of fabric softener to ½ litre of water and
pour into dispenser II.
g
Reduce the detergent dosage for the next wash cycle.
Repeat spin cycle.
This is not a fault.
Unbalanced load detection system is attempting to
compensate the imbalance by spinning the washing
several times.
Always load large and small items together into the
drum.
The laundry was not spun.
Large laundry items have become entangled and are
not evenly distributed in the drum. For reasons of
safety the high speed spin cycle was automatically
suppressed.
Always load large and small items together into the
drum.