Kleenmaid KFL2000 - Manual (Page 6)

6
The accessory parts bag contains:
1. Covers to be placed over the
openings when the transportion
bolts have been removed.
2. Elbow for attaching the drain hose,
e.g. into a wash basin.
3. Wrench for adjustment.
4. Lock for drainage hose.
Depending on the connection
situation, the following part is also
required:
- 1 hose clip Ø 24-40 mm
(DIYĂstore) is also required for
connection to a siphon.
Moisture in the drum is due to the final
inspection which every washing
machine undergoes before it leaves
the factory.
On the rear of the appliance:
- Power cord with plug.
C....Connection for supply hose
Useful tools
The following tools are helpful:
1. Flat head screwdriver.
2. Socket wrench (1/2" / 13mm).
3. Closed wrench (1/2" / 13 mm).
4. Spirit level for adjustment.
Dimensions
a = 686 mm
b = 780 mm
c = 940 mm
d = 407 mm
Opening angle 180°
Weight approx. 100 kg
Checklist for
Installation
Page
completely remove 4 shipping bolts
and move the washer into place
7
connect the water supply line and
drain pipe
8
connect the electrical power 9
slide the washer into its final location 10
level the washer as low as possible 10
before first use, run a cleaning cycle 13
Installation surface
Stability is important to prevent the
washing machine from wandering"
during the spin cycle.
The installation surface must be solid
and level. Soft floor surfaces, such as
carpets or surfaces with foam
backing, are not suitable.
If the washing machine is to be
installed on a wooden floor:
q If possible, install the washing
machine in a corner.
q Screw a water resistant wooden
board (min. 30 mm thick) to the
floor.
q Secure the front feet of the
washing machine with holding
brackets.
Holding brackets (set) can be
obtained from a specialist store
orĂthe Customer Service
(WMZ 2200).
q The appliance cannot be
topĆmounted.
q The appliance cannot be built
under.
Installation of base
If the washing machine is installed on
a base (order no. WMZ 20400), follow
the instructions in the operating
manual!
i Install the holder BEFORE
removing the transportation
protection devices.