Ap pe nd ix, Headphones, Usb (midi) – Kawai CN35 Owner’s Manual User Manual
Page 123: Mp3/wav/smf files
123
Ap
pe
nd
ix
Headphones
Issue
Possible Cause and Solution
Page no.
The headphone volume is too low.
If the ‘Nominal Impedance’ specification of the headphones is less than
100 Ω (ohms), set the ‘Phones Volume’ setting in the Basic Settings
menu to High.
p. 81
USB (memory device)
Issue
Possible Cause and Solution
Page no.
A USB memory device is not detected, cannot
be saved to, or does not appear to function
when connected to the ‘USB to Device’ port.
Check that the USB memory device is formatted to use the FAT/FAT32
filesystem, and not set to ‘Write Protect’ mode.
p. 120
Disconnect the USB memory device, turn the instrument off then on,
then reconnect the USB device. If the USB device still does not function,
it may be damaged or incompatible. Please try using a different USB
device.
–
The instrument pauses briefly when connecting
a USB memory device.
This is recognised behaviour when using very large capacity (e.g.
8GB+) USB memory devices.
–
USB (MIDI)
Issue
Possible Cause and Solution
Page no.
The instrument is connected to the computer
using a USB cable, however the software does
not respond to key presses.
Check that a USB MIDI driver is installed on the computer.
p. 121
Check that ‘USB Audio Device’ or ‘KAWAI USB MIDI’ is selected in the
software’s input/output device settings.
p. 121
MP3/WAV/SMF files
Issue
Possible Cause and Solution
Page no.
No sound can be heard when playing an MP3
or WAV audio file stored on a USB memory
device.
Check that the audio player volume is not set to 0.
p. 54
Check that the format of the audio file is supported and listed in the
‘Audio Player supported format specifications’ table.
p. 53
An MP3/WAV audio file stored on a USB
memory device sounds strange, or does not
play back correctly.
Check that the format of the audio file is supported and listed in the
‘Audio Player supported format specifications’ table.
p. 53
The file transfer speed of the USB memory device may be too slow to
play the audio file. Please try using a different USB memory device,
ensuring that it conforms to USB2.0 Hi-Speed standards.
p. 120
When recording MP3/WAV audio files, the
volume is too low/too high (distorted).
Check the ‘Audio Recorder Gain’ setting before recording the audio,
and if necessary adjust to increase/decrease the recording level.
p. 83