Kawai CN35 Owner’s Manual - Manual (Page 120)

120
Ap
pe
nd
ix
Connecting to Other Devices
Jack Panel
„
LINE IN jacks (1/4” phone jack)
These jacks are used to connect a pair of stereo outputs from
other electronic instruments or audio equipment to the CN35
digital piano’s speakers. To adjust the LINE IN level, please use
the volume controls on the device itself.
To connect a device in mono, connect the cable to the L/MONO
jack only.
„ USB to Host port (‘B’ type)
This USB port is used to connect the CN35 digital piano to
a computer or iPad using an inexpensive USB cable. When
connected, the instrument can be used as a standard MIDI
device, allowing it to send a receive MIDI data. Connect a ‘B’
type USB connector to the instrument, and an ‘A’ type USB
connector to the computer.
With additional conversion adaptors, this port may also be used
to connect the CN25 digital piano to tablets such as the Apple
iPad and other mobile devices.
* Please refer to page 121 for more information about USB MIDI.
„
LINE OUT jacks (1/4” phone jack)
These jacks are used to connect the stereo output of the CN35
digital piano’s sound to external speakers, amplifiers, mixers,
recording devices, and similar equipment.
Mono signals will be output only if a cable is connected to the
L/MONO jack.
The MASTER VOLUME slider does not affect the LINE OUT level.
* The ‘Line Out Volume’ setting can be used to adjust the level of the
LINE OUT signal. Please refer to page 82 for more information.
„
MIDI IN/OUT jacks
These jacks are used to connect the CN35 digital piano to
external MIDI devices, and also to a computer with a MIDI
interface as an alternative to the ‘USB to Host’ port.
* Please refer to page 1 of “CN35 MIDI Settings Manual” for more
information about MIDI.
Headphone Panel
„
PHONES jacks (1/4” phone jack)
These jacks are used to connect stereo headphones to the CN35
digital piano. Two pairs of headphones can be connected and
used simultaneously. When a pair of headphones is connected,
sound will not be produced by the speakers.
„
USB to Device port (‘A’ type)
This USB port is used to connect a USB memory device to the
CN35 digital piano. This allows MP3/WAV audio files, and SMF
song files to be played directly. It is also possible to record
performances to MP3/WAV audio files and SMF, and save
recorder songs stored in internal memory for posterity.
„
USB device information
ƒ The ‘USB to Device’ functionality of the CN35 digital piano
conforms to USB2.0 Hi-Speed standards. Older USB devices
can still be used, however data transfer speed will be limited
to the maximum transfer speed of the device.
ƒ The ‘USB to Device’ port is intended for connecting USB
memory devices, however USB floppy drive devices can also
be used to save recorder songs stored in internal memory, or
play SMF song files.
ƒ It may be necessary to format the USB memory device before
it can be used with the CN35 digital piano. If so, please refer to
the USB Format function instructions on page 74. Formatting
the device will erase all data.
ƒ Avoid removing the USB memory device while data is being
loaded or saved, files are being renamed or deleted, or the
device is being formatted.
ƒ Other USB devices, such as computer mice, keyboards, or
battery chargers etc. cannot be used with this instrument.