Kawai CN35 Owner’s Manual - Manual (Page 117)

117
Ap
pe
nd
ix
1. Attaching the side panels b to the pedal board d
Unfasten and extend the pedal connection cable attached to
the bottom of the pedal board d.
Attach the left and right side panels b to the pedal board d
using the temporary mounting screws located on either end of
the pedal board.
Ensure that the pedal board and side panels make close contact,
and that there are no large gaps between the assembled parts.
Insert two short silver tapping screws j into the holes at either
end of the pedal board (four screws in total), and securely fasten
the left and right side panels.
2. Attaching the back board c
Allow the assembled pedal board and side panels to stand
upright (vertically) on the floor.
Loosely attach the back board c to the left and right side
panels using the four long black or silver tapping screws h.
Loosely attach the back board to the pedal board using the four
mid-length black or silver tapping screws i.
Adjust the positioning of the pedal board, side panels, and
backboard to ensure that all parts are in alignment, then firmly
tighten all the screws.
3. Mounting the main body a onto the stand
Ensure that two or more people undertake the
following step of the assembly process.
Place the assembled stand against a wall to prevent it from
moving/leaning backwards.
Carefully lift the main body a onto the stand, and gradually
slide the unit backwards until it is aligned with the rear of the
side panels.
When sliding the main body into the stand, be
careful not to catch/trap hands and fingers.
Securely fasten the main body to the stand using the four screws
with spring washers g.
Tighten all screws securely to ensure that the
main body is firmly attached to the stand.
j
d
Temporary
mounting
screw
b
j
h
i
c
i
i
i
h
h
h
g
g
g
g
a