Ivoclar Vivadent IPS e.max CAD-on - Manual (Page 25)

25
Comparison: IPS e.max ZirCAD framework after CAM process (above)
and after correction of the attachment point (below).
Comparison: Attachment point area before (left) and after (right) grinding.
Finishing
of
the
Framework
and
V
eneering
Structur
e
Do not smooth out rough areas on the IPS e.max ZirCAD framework surface, as this
unnecessarily increases the size of the joint.
Smooth out the attachment point with suitable grinding instruments.
Observe the minimum layer thickness of the IPS e.max ZirCAD framework!
Do not "post-separate" the bridge framework with a separating disk.
Check the layer thickness next to the attachment point and reduce the IPS e.max ZirCAD frame-
work at the attachment point to this layer thickness.
Do not grind the circular collar created by the software on the IPS e.max ZirCAD framework. Carefully separate the milled IPS e.max ZirCAD framework from its holder using a diamond-
coated separating disk.