Ivoclar Vivadent IPS e.max CAD Abutment Solutions - Manual (Page 36)

36
Characterization/Glaze firing with IPS e.max CAD Crystall./…
The following paragraphs will explain the steps of characterizing and glazing with IPS e.max CAD Crystall./Shades, Stains
and Glaze.
If hybrid abutment crowns are fabricated, the entire outer surface may be
individually characterized.
If hybrid abutments are fabricated, only the area of the
emergence profile is characterized with
IPS e.max CAD Crystall./Shades, Stains and Glaze.
Required materials
– IPS e.max CAD Crystall./Shades are ready-to-use "Dentin" stains in syringes.
Shade
Incisal 1
Shade
Incisal 2
Shade 0 Shade 1 Shade 2 Shade 3 Shade 4
– IPS e.max CAD Crystall./Stains are ready-to-use intensive stains in syringes.
white cream sunset copper olive khaki mahogany
– IPS e.max CAD Crystall./Glaze Paste is a ready-to-use glazing paste.
– IPS e.max CAD Crystall./Glaze Liquid is a special liquid for mixing with Shades, Stains and Glaze.
Note:
The IPS e.max CAD Crystall./Glaze Spray is not recommended for glazing IPS e.max CAD Abutment Solutions,
as is requires very targeted application. The glazing material must neither reach the bonding surface to the Ti
base nor the screw channel, as this may compromise the accuracy of fit.