Ivoclar Vivadent IPS e.max CAD Abutment Solutions - Manual (Page 27)

27
Staining technique on the "blue restoration"
Combination Firing
with IPS e.max CAD Crystall./
materials
Staining technique on the "blue restoration"
Characterization and glaze with IPS e.max CAD Crystall./ materials on the "blue" restoration, followed by Combination firing
The following paragraphs will explain the steps of glazing and characterizing with IPS e.max CAD Crystall./Shades, Stains
and Glaze. In this processing technique, Crystallization and Glaze firing are performed in one step. Characterizations are
applied using IPS e.max CAD Crystall./Shades and Stains.
If hybrid abutment crowns are fabricated, the entire outer surface
may be individually characterized.
If hybrid abutments are fabricated, only the area of the
emergence profile is characterized with IPS e.max CAD
Crystall./Shades, Stains and Glaze.
Required materials
– IPS e.max CAD Crystall./Shades are ready-to-use "Dentin" stains in syringes.
Shade
Incisal 1
Shade
Incisal 2
Shade 0 Shade 1 Shade 2 Shade 3 Shade 4
– IPS e.max CAD Crystall./Stains are ready-to-use intensive stains in syringes.
white cream sunset copper olive khaki mahogany
– IPS e.max CAD Crystall./Glaze Paste is a ready-to-use glazing paste.
– IPS e.max CAD Crystall./Glaze Liquid is a special liquid for mixing with Shades, Stains and Glaze.
Note:
The IPS e.max CAD Crystall./Glaze Spray is not recommended for glazing IPS e.max CAD Abutment Solutions,
as it requires very targeted application. The glazing material must neither reach the bonding surface to the Ti
base nor the screw channel, as this may compromise the accuracy of fit.
Completing the IPS e.max CAD Ceramic Structure
– Staining T
echnique on the Blue Restoration